Products
 Home > NewsNews

Steel plate UT

View: 195404/27/2017  


Ultrasonic Testing (UT)


Ultrasonic Testing (UT) utilizes sound energy at high frequencies, in order to provide examinations and measurements of the  plate product. This aids in flaw detection/evaluation, dimensional measurements, etc.


Ultrasonic testing uses the same principle as is used in naval SONAR and fish finders.  Ultra-high frequency sound is introduced into the part being inspected and if the sound hits a material with a different acoustic impedance (density and acoustic velocity), some of the sound will reflect back to the sending unit and can be presented on a visual display.  By knowing the speed of the sound through the part (the acoustic velocity) and the time required for the sound to return to the sending unit, the distance to the reflector (the indication with the different acoustic impedance) can be determined.  The most common sound frequencies used in UT are between 1.0 and 10.0 MHz, which are too high to be heard and do not travel through air.  The lower frequencies have greater penetrating power but less sensitivity (the ability to "see" small indications), while the higher frequencies don't penetrate as deeply but can detect smaller indications.

The two most commonly used types of sound waves used in industrial inspections are the compression (longitudinal) wave and the shear (transverse) wave, as shown in Figure 10.  Compression waves cause the atoms in a part to vibrate back and forth parallel to the sound direction and shear waves cause the atoms to vibrate perpendicularly (from side to side) to the direction of the sound.  Shear waves travel at approximately half the speed of longitudinal waves. 

Sound is introduced into the part using an ultrasonic transducer ("probe") that converts electrical impulses from the UT machine into sound waves, then converts returning sound back into electric impulses that can be displayed as a visual representation on a digital or LCD screen (on older machines, a CRT screen).  If the machine is properly calibrated, the operator can determine the distance from the transducer to the reflector, and in many cases, an experienced operator can determine the type of discontinuity (like slag, porosity or cracks in a weld) that caused the reflector.  Because ultrasound will not travel through air (the atoms in air molecules are too far apart to transmit ultrasound), a liquid or gel called "couplant" is used between the face of the transducer and the surface of the part to allow the sound to be transmitted into the part.


Steel plate UT

Testing of raw materials。

Companies in strict accordance with the quality requirements of all raw materials testing。

“Steel plate UT”的图片搜索结果


The inspector is routinely checking the plate UT。


material45#
size11800*2000*30
usesheave plate


Related products
Hot Rolling sheave
Hot Rolling sheave
Full forging sheave/solid sheave
Full forging sheave/solid sheave
Ring forging sheave
Ring forging sheave
Ring forging
Ring forging
View More(Total0)Comment Lists
No Comment
I want to comment
Content *
Verification Code*
中文
Hrvatska
Français
Italiano
Português
日本の
한국어
العربية
Deutsch
česky
Dansk
Nederlands
suomi
Ελληνικά
हिन्दी
norsk
Türkiye
ประเทศไทย
български
русский
Svenska
Polski
Română
Việt Nam
ewm